OK
We are using Cookies in order to make your visit to our website more efficient. We assume you agree to this.

General assembly instructions

1. Add-on learner bike brake kit

Please find further information on the pdf.

2. Disassembly of a wheel cap

Please use an old screw driver or pick. Put the cone end onto the "nose" of the wheel cap (see photo). Please pound the screw drivers grip with a hammer. The cap will loosen. Note: the cap cannot be used a second time. It must be replaced by a new one.

3. Assembly of a wheel cap

Please put the cap onto the axle and straightly pound with a hammer.

4. Disassembly of a tricycle front wheel

On the left side of the driving direction you will find the so called pivot-bearing within the fork (see photo): Lift the top of the bearing a little bit and turn it by 270° (3/4 turn) in clockwise direction. Push the bearing on the right side of the fork towards the wheel. The noses of the bearing are now vertical to the fork opening and the wheel can be taken out of the fork (possibly you need to shake it a little bit)

5. Assembly handlebar Z

Please have a look to the pdf for further information.

6. Assembly handlebar ZL

Please have a look to the pdf for further information.

7. Assembly of a cantilever brake

Please have a look to the pdf for further information.


Debug lschen